Blasher: Getting Started

Applies to: Rev A

Flash firmware with the web app

  1. Install Silicon Labs’s CP210x USB to UART Bridge VCP Drivers if the board does not show up as a serial port.
  2. Plug the Blasher into USB and connect the 5-pin UART breakout to the target’s UART breakout.
    • The target must be powered separately, Blasher does not power it.
  3. Open blasher.scalpelspace.com and click Connect.
  4. Drop the firmware .bin image into the Firmware image box.
  5. Click Flash firmware.

Serial monitor

With the Blasher connected, switch the web app to the Serial monitor tab for a simple serial terminal to the target.


This site uses Just the Docs, a documentation theme for Jekyll.