SPI-CAN Breakout: Getting Started

Applies to: Rev A

  1. Wire the 8-pin header to your host:
    1. 5 V power.
    2. GND ground (second pin optional).
    3. SPI lines (COPI, CIPO, CS and SCK).
    4. Optionally, but recommended: interrupt INT pin.
  2. Set the logic level jumper to match your host, the default logic level is 5 V.
  3. Set bus termination on (120 mark) or (NC mark) off depending on where the board sits on the bus (enable 120 Ohm only at the physical ends of the bus).
  4. Connect the 3-pin CAN side to your bus (GND, CAN high, CAN low).
  5. Flash the example firmware or and confirm the link.
  6. Optional: For larger projects using ScalpelSpace products, use the ScalpelSpace Bus Arduino Library for ScalpelSpace’s unified CAN ID allocation scheme and device control.

This site uses Just the Docs, a documentation theme for Jekyll.